1971 XLCH Sportster 
This is how it looked after sitting for 13 years inside my saltwater boatshed. Sad shape to say the least. I thought to take this photo right after I pulled the carb off. 5 years later I was glad I had taken the shot.
This is how it looked after sitting for 13 years inside my saltwater boatshed. Sad shape to say the least. I thought to take this photo right after I pulled the carb off. 5 years later I was glad I had taken the shot.
Viewed: 762 times.

Turning front brake drum on my 10 inch South Bend lathe.
Turning front brake drum on my 10 inch South Bend lathe.
Viewed: 455 times.

Front Brake Drum in South Bend lathe chuck. Turning is complete and time to build the front wheel.
Front Brake Drum in South Bend lathe chuck. Turning is complete and time to build the front wheel.
Viewed: 340 times.

Home made pinion gear puller
Home made pinion gear puller
Viewed: 380 times.

Piniongear is removed using homemade tool.
Piniongear is removed using homemade tool.
Viewed: 387 times.

Lower end going back together- September 1997
Lower end going back together- September 1997
Viewed: 386 times.

Lower unit-timing side september 1997
Lower unit-timing side september 1997
Viewed: 375 times.

Valve train components
Valve train components
Viewed: 364 times.

Homemade 1 inch high riser detail.
Homemade 1 inch high riser detail.
Viewed: 370 times.

Lathe turned Risers
Lathe turned Risers
Viewed: 363 times.

Risers pre-mounted with 2 piece handlebars prior to paintwork.
Risers pre-mounted with 2 piece handlebars prior to paintwork.
Viewed: 360 times.

Building Rear Wheel
Building Rear Wheel
Viewed: 381 times.

Powered by Gallery v1 RSS